Allmand PORT-A-LITE PAL50 Single LED Manuel D'utilisation page 6

3
Operation
Preparing The Unit For Use
WARNING
Unsafe Operation Hazard.
Operating the unit with worn, damaged or missing parts
can result in death or serious injury. Always replace worn,
damaged or missing parts promptly. Do not operate this
unit until all worn, damaged or missing parts have been
replaced, and proper operation of unit has been verified.
6
NOTICE
We encourage the use of authorized Allmand
parts. The warranty does not cover damage or performance
problems caused by the use of parts that are not authorized
replacement parts.
1. Check that a copy of the Operator's Manual is with the
unit.
2. Check that all safety decals are legible and in place on
the unit. See Safety Decals in the Safety section of
this manual.
3. Check the unit for proper operation. (See Operating The
Unit for detailed information on operating procedures.)
• Check that the inner mast extends and retracts
properly, and that inner mast can be locked in each
height position with the latch spring pin.
• Check that the LED fixture hardware is tightened.
• Check that the power cord, base cable and fixture
cable are not frayed or damaged, and that the
connectors are not damaged.
• Check that the mast socket knob securing the outer
mast to the base assembly is tightened.
• Check the condition of the wheels, and that they roll
freely.
4. Plug the power cord into a wall outlet or power generator.
See Specifications for detailed information on power
requirements.
5. Turn the power switch to the ON position to check the
LED fixture. See Troubleshooting if the LED fixture
does not light. When finished, set the power switch to the
OFF position and disconnect the power cord from the wall
outlet or power generator.
Work Site Considerations
Prior to setting up and operating the work light, the operator
must determine where to place it on the work site. It is the
operator's responsibility to ensure that the work light is
properly and safely positioned on at the work site. Be sure to
follow rules or instructions for your work site, and any state,
province and federal rules that may apply.
®
replacement