Évacuation Par Le Haut - Travis Industries GreenField Manuel D'utilisation

6
Évacuation Par Le Haut
Remove the outer flue
assembly, cover plate, and
gaskets. Place the screws
and components aside (for
all subsequent steps).
Remove the inner flue
assembly and exhaust cover
plate.
ADJUSTING THE DIFFUSER ON THE INNER FLUE ASSEMBLY
Rear vent configurations with no rise require the
diffuser to be bent to the # 2 position. It is easiest
to adjust this component with the inner flue
removed. See the directions below.
Bottom of inner
flue assembly
© Travis Industries
Fonctionnement
Inner Flue
Assembly
DIFFUSER SIDE VIEW
Before (Stock - Position # 1)
a
After (Position # 2)
Remove the
diffuser.
4100326
NOTE: Use a magnetic-tipped
nutdriver on these screws - take
care to prevent the screws from
falling into the intake channel.
Exhaust Cover Plate
b
Bend the round portion of the
diffuser so it is bent (position # 2).
c
Replace the
diffuser.
100-01250_000