Motorola Solutions CLS Serie Guide D'utilisation page 12

MN006468A01-AB
Chapter 1: Product Overview
1.8.1
Addendum to CLS Multi-Unit Charger
Mount the Motorola CLS Multi-Unit Charger (MUC) either to a wall or place it on a flat surface such as
a table or desk. Wall mounting the MUC requires 4 holes to be drilled into the wall (2 holes each side).
Then secure the MUC to the wall using 4 screws or fasteners appropriate for particular wall mounting
surface material.
Procedure:
1 Fold down the lower mounting brackets on the rear of the MUC.
2 Hold the MUC against the wall in the desired location.
3 From this position, raise the MUC approximately 1.6 inch, then use the slots in the lower
mounting bracket as a guide to mark and drill a hole for each upper bracket.
4 Install 2 fasteners appropriate for the wall material, but do not tighten fasteners flush to the wall.
5 Hang the MUC on the 2 fasteners by the upper mounting brackets.
6 Use the slots in the lower mounting brackets as a guide to mark and drill the lower mounting
holes.
7 Install 2 fasteners, appropriate for the wall material, and tighten them against the lower mounting
brackets.
12