Initial Start-Up - SilverCrest SKM 500 A1 Mode D'emploi

GB

Initial start-up

96
WARNING! RISK OF INJURY!
► Caution: the cutting knife, the cutting, shredding and grating discs and the
mixing knife are extremely sharp! For this reason, take care when cleaning.
► Caution: the cutting knife, the cutting, shredding and grating discs and the
mixing knife are extremely sharp! For this reason, take care when emptying
the mixing bowl and the blender.
► When the appliance is operating, do not put anything other than the ingre-
dients to be processed into the mixing bowl or the blender.
► Do not put hands and foreign objects in the to fi lling shaft or the mixer to
avoid the risk of injury or damage to the appliance.
► Do not change accessories unless the drive is stationary and the mixer is
unplugged from the power supply! The appliance will run on for a short
time after being switched off !
► Never leave the appliance unattended!
► Before changing accessories or additional parts that are in motion during
operation, the appliance must be switched off and disconnected from
mains power.
CAUTION - PROPERTY DAMAGE!
► Never fi ll the blender with boiling fl uids, such as soup! Allow these to cool
until lukewarm.
■ Clean the appliance as described in the chapter "Cleaning and Care".
■ Place the appliance on a fl at and clean surface.
■ Attach the appliance to the subsurface with the suction cups so that it is fi xed.
Unwind the power cord from the cord storage a and then attach it to the
■
cable leadthrough.
■ Assemble the appliance as described in the chapter entitled "Assembly"
depending on the type of use.
SKM 500 A1