Unpacking And Setting Up; Dismantling The Device - SilverCrest SKM 600 B2 Notice Succincte

Protect the base unit against moisture,
water drips and splashes.
Never touch the device with wet hands.
The device is not fully disconnected from
the power supply, even after it is
switched off. In order to fully disconnect
it, pull out the mains plug.
Never put your hands between the drive
arm and the housing. There is a risk of
injury from crushing when folding
down.
Do not touch rotating parts with spoons
or similar utensils. Keep long hair and
loose clothing away from the rotating
parts.
Always ensure that the speed control is
set to 0 before you plug the mains plug
into the wall socket.
The mixing mechanism must not be op-
erated continuously for longer than
10 minutes at a time. You must then al-
low the device to cool down to room
temperature.
Only use the original accessories.
Overview
1 Unlock button (for the drive arm)
2 Turbo 0 - 8: speed control with on/off
function
3 Power cable with mains plug
4 Dough hook
5 Mixing bowl
6 Whisk
7 Beater
8 Suction foot
9 Base unit
10 Filling opening
11 Splash guard
12 Drive arm
13 Axle for holding mixing tools
14 Cable spool
10 GB

Unpacking and setting up

1. Remove all packing material.
2. Check to ensure that all parts are pres-
ent and undamaged.
3. Disassemble the device.
4. Clean the device prior to first use!
5. Figure B: wind the excess power cable
around the cable spool 14 on the un-
derside of the base unit 9.
6. Place the base unit 9 on a level, dry
and waterproof surface, so that the de-
vice can neither fall nor slip off.
Select a smooth, clean surface, so that
the suction feet 8 can stick firmly in
place and ensure a secure grip.
CAUTION:
Overflowing liquid would flow onto the
surface. You should therefore place the
device on a waterproof surface.

Dismantling the device

DANGER from rotating parts!
Turn off the device and unplug the
mains plug 3 from the wall socket be-
fore disassembling the device.
1. Press the unlock button 1 and fold up
the drive arm 12 until it engages and
the unlock button 1 pops out again.
2. Push the mixing tool 4/6/7 slightly up-
wards and turn it anticlockwise until it
can be pulled off the axle 13.
3. Turn the splash guard 11 towards the
open lock symbol until it can be removed.
4. Turn the mixing bowl 5 towards the
open lock symbol until it can be re-
moved.
5. Press the unlock button 1 and move the
drive arm 12 all the way down. The un-
lock button 1 pops out again.