Tripp-Lite PDUMH15AT Manuel Du Propriétaire page 9

3. Features
A
Link LED Color
A
Off
Flashing Amber
Flashing Green
201011143 93-2857.indb 9
(continued)
Digital Load Meter (Ammeter): The total electrical current used
by the PDU is displayed on the digital meter in amperes.
Input Source Indicator: When the PDU is connected to a live AC
power source, the Primary or Secondary input LED illuminates to
indicate which source is supplying power to the PDU outlets.
Accessory Slot: An optional SNMP card may be installed in the
slot, allowing the PDU to be configured, controlled and monitored
remotely. Contact Tripp Lite Customer Support at (773) 869-1234
for more information.
Factory Port: The port is reserved for configuration by factory
authorized personnel only. Do not connect anything to the port.
For Models with SNMP Network Card Installed:
PS/2 Port: Use this port to connect a Tripp Lite ENVIROSENSE
environmental sensor to provide remote temperature/humidity
monitoring and a dry contact interface to control and monitor alarm,
security and telecom devices. Contact Tripp Lite Customer Support
at (773) 869-1234 for ordering information. Note: Do not connect
a keyboard or mouse to this port.
Mini-DIN Serial Port: Use this port to provide a direct terminal
connection to a computer with a terminal emulation program. A
serial cable (part number 73-1025) is included with the PDU. If you
need to order a replacement cable, contact Tripp Lite Customer
Support at (773) 869-1234.
Ethernet Port: Use this RJ-45 jack to connect the PDU to the
network with a standard Ethernet patch cable. The Link LED
Status LED
B
table below. This port is not compatible with PoE (Power Over
Ethernet) applications.
B
Network Operating Conditions
No Network Connection
100 Mbps Network Connection
10 Mbps Network Connection
indicate several operating conditions, as shown in the
Status LED Color
B
Off Card Not Initialized
Steady Green Card Initialized and Operational
Flashing Amber Error - Card Not Initialized
9
and
A
12/8/2010 2:03:54 PM