Testing Network Connection - Tripp-Lite PDUMH15AT Manuel Du Propriétaire

2. Installation
order to assign an IP address to the PDU. The
default terminal mode root password is
TrippLite. Sample IP settings are shown -
supply your own IP information when you
configure your PDU.
Press A to Accept the settings, or M to Modify? M
Enter the root password: *********
Reset configuration to default values (Y/N)? N
For each of the following questions, you can
press <Return> to select the value shown in
braces, or you can enter a new value.
NETWORK INTERFACE PARAMETERS:
Should this target obtain IP settings from the network?[N] N
Static IP address [192.168.1.19]? 192.168.0.123
Static IP address is 192.168.0.123
Subnet Mask IP address [255.255.0.0]? 255.255.255.0
Subnet Mask IP address is 255.255.255.0
Gateway address IP address [192.168.1.1]? 192.168.0.1
Gateway address IP address is 192.168.0.1
You can also change the root password, real-time clock and other settings. (Tripp Lite recommends
against changing the default settings unless you are an advanced user with a specific purpose.)
After you have finished entering settings, the PDU will save changes to memory and reboot (this
may take several minutes). After the PDU reboots, the initialization page should display the new
static IP settings.
2.5F Remove Serial Cable: Remove the serial cable from the PDU and proceed to Step

2.6 Testing Network Connection

2.6A Access PDU with Web Browser:
After an IP address has been assigned to the
PDU, attempt to access it with a Web browser
that supports frames, forms and Java
a Web browser on a computer connected to
the LAN and enter the IP address assigned to
the PDU. You should be prompted for a
password . The user name is admin and the
A
default password is admin. After you enter the
user name and password, the PowerAlert
Status page will appear in the browser
B
window. For more information about
configuration and operation of the PDU via the
PowerAlert interface, refer to the
SNMPWEBCARD User's Guide, included on the
CD-ROM bundled with the PDU.
Note for Network Management System Users Only:
Two MIB files - Tripplite.mib and RFC1628.mib - must
be loaded on each Network Management Station that
will monitor the PDU via SNMP . The files are provided
on the CD-ROM included in the product package.
201011143 93-2857.indb 7
(continued)
™ . Open
7
2.5E
A
B
.
2.6A
12/8/2010 2:03:52 PM