Network Connection - Tripp-Lite DU3VN Serie Manuel Du Propriétaire

Masquer les pouces

Table des Matières

Les langues disponibles

Installation

Static IP Address Assignment

4-5

Configure PDU in Terminal Mode: After a brief pause, an initialization page should

appear in the terminal emulation program. Press any key on the keyboard within 10

seconds to change the PDU settings. (If the 10-second period has elapsed, you can reboot

the PDU by powering down completely and then restoring power.)

Follow the sequence of responses below in order to assign an IP address to the PDU. The

default terminal mode root password is TrippLite. Sample IP settings are shown - supply

your own IP information when you configure your PDU.

Press A to Accept the settings, or M to Modify? M

Enter the root password: *********

Reset configuration to default values

(Y/N)? N

For each of the following questions, you

can press <Return> to select the value

shown in brackets, or you can enter a new

value.

NETWORK INTERFACE PARAMETERS:

Should this target obtain IP settings from

the network?[N] N

Static IP address [192.168.1.19]?

192.168.0.123

Static IP address is 192.168.0.123

Subnet Mask IP address [255.255.0.0]? 255.255.255.0

Subnet Mask IP address is 255.255.255.0

Gateway address IP address [192.168.1.1]? 192.168.0.1

Gateway address IP address is 192.168.0.1

You can also change the root password, real-time clock and other settings. (Tripp Lite

recommends against changing the default settings unless you are an advanced user with

a specific purpose.) After you have finished entering settings, the PDU will save changes

to memory and reboot (this may take several minutes). After the PDU reboots, the

initialization page should display the new static IP settings.

4-6

Remove Serial Cable: Remove the serial cable from the PDU and proceed to Step