V . C O M F O R T A D J U S T M E N T S
TILLER ANGLE ADJUSTMENT (See figure 4)
WARNING! Remove the key from the key
switch before adjusting the tiller or the
seat. Never attempt to adjust the tiller or
the seat while the PMV is in motion.
NOTE: In order to fully lower the tiller for purposes of disas-
sembly or transport, you must first completely remove the
seat.
MIRROR POSITION
To install the mirror (see figure 4):
1. Determine on which side to install the mirror and
remove the rubber plug from the top of the tiller
handle.
2. Insert the threaded end of the mirror holder into the
opening and rotate it clockwise until snug.
3. If necessary, rotate the nut clockwise to secure the
mirror in place.
To adjust the mirror:
1. Position yourself in a seated driving position facing
forward.
2. Adjust the mirror left, right, up, or down until you have
a good line of sight behind you.
TILLER HEIGHT ADJUSTMENT
The height of the tiller console can be adjusted up or down
to a comfortable driving level.
WARNING! This procedure should only be
perfomed by an authorized Provider.
To adjust the tiller height:
1. Insert a 5 mm hex key into the opening on the side of
the tiller and loosen the bolt. See figure 16.
2. Move the tiller up or down to a comfortable position.
3. Tighten the bolt.
CONSOLE ANGLE ADJUSTMENT
The console can be adjusted to a comfortable driving
angle.
WARNING! This procedure should only be
perfomed by an authorized Provider.
To adjust the console angle:
1. Insert a 6 mm hex key into the opening on the side of
the tiller and loosen the bolt. See figure 16.
2. Adjust the tiller to a comfortable driving position.
3. Tighten the bolt.
24
IDENTIFICATION KEY
1. SEATBACK ADJUSTMENT LEVER
2. SEAT ROTATION LEVER
3. ARMREST ANGLE ADJUSTMENT DIAL
4. SEAT SLIDING LEVER
5. ACCESSORY BRACKET
6. DETENT PIN
5
3
4
Figure 15. Seatback Adjustment
IDENTIFICATION KEY
1. CONSOLE ANGLE ADJUSTMENT
2. TILLER HEIGHT ADJUSTMENT
1
2
Figure
16.
Tiller
Height/Console
Adjustments
6
1
2
Angle
PMV Series