Pride Mobility PMV Serie Manuel Du Propriétaire page 10

S E T T I N G I N F O R M A T I O N C H A R T
SETTING
Odometer
Tripometer
Temperature
Clock
Chart 1. LCD Control Panel Information
Press MODE until the setting you want to change appears on the LED screen. Press and hold SET then
follow the steps corresponding to your setting in chart 2.
ODO
Press MODE
OPERATION
Use SET to
SELECTION select option
EXIT Press MODE
Chart 2. LCD Control Panel Information
Battery Charging Mode
During battery charging, the console will display the clock and the battery condition indicator.
Battery Condition Indicator
When the key is turned to the "on" position, this LED indicator gives an approximate reading of battery
strength. When the PMV's battery voltage reaches a low enough level, a warning beep will sound once,
indicating the batteries need charging. The warning beep will not sound again until the PMV is restarted
or the throttle control lever is pressed.
Maximum Speed Indicator LED
The maximum speed indicator displays the maximum speed selected with the speed adjustment buttons.
The more bars that are lit, the faster the speed. The maximum PMV speed will be determined by the HIGH-
LOW setting, which limits the maximum speed to half when set to LOW. The actual travel speed will be
shown in the speed display on the LCD screen.
10
I I . Y O U R P M V
CODE
Measures mph, km/h, and hours of use. Also displays
ODO
total distance traveled over life of PMV. (Cannot be
reset.)
Displays trip distance traveled. (Can be reset to "0".)
TRIP
Displays current temperature in °F or °C.
TEMP
Displays time in 12-hour (AM/PM) or 24-hour.
TRIP TEMP
Press MODE Press MODE
for 2 seconds
then release
Press and Use SET to
hold SET choose °F or
until option °C
resets to 0.0
Press MODE Press MODE
INFORMATION
Press MODE (hour digits flash)
Use SET to change hours. Alternate
pressing MODE and SET to change
minutes and AM/PM.
Press
PMV Series