Kimberly-Clark PROFESSIONAL ICON Guide Utilisateur page 6

Cage Installation (continued)
6. Test the fit of the dispenser in
the hole.
7. Determine if additional framing
is needed for the install. For
jobs on 16 inch centers,
additional framing will be
needed. Use 2 x 4"'s and 1 x
4"'s and balance the framing
on each side as needed.
8. Measure the fit to the dispenser
again to ensure that the fit will
be right. Shims may be needed
at this point.
9. Insert the unit into the wall.
10. Before adding screws, check
to see that the unit is level.
11. Install dispenser using 4 screws
in the side of the housing
attaching to the studs in the
wall. Add 2 screws on the top
side and two on the bottom
side of the housing. Do
not overtighten.
6.
8.
9.
11.
7.
10.