Module Installation - Kimberly-Clark PROFESSIONAL ICON Guide Utilisateur

Module Installation

For instructions on how to install
the module into a wall-mounted
Roll Hand Towel Dispenser, please
refer to the Automatic Roll Towel
Dispenser instructions found on
www.kcprofessional.com.
Note: Install the housing assembly
into the wall before installing the
module. For instructions on how to
install the housing assembly, go to
www.kcprofessional.com.
1. Remove the cover by closing
it about halfway. Align bottom
edge of cover with vertical
alignment line. The key
feature on the inside of the
cover should line up with it's
corresponding slot on the
dispenser body, allowing the
cover to be flexed off.
2. Remove the cover.
3. Once the housing assembly
is installed, align the back of
the module with the angled
posts on the back wall and
lower into position. Ensure
that the module is level
once positioned.
4. Insert screws, one on each
side, to secure the module
in its position inside the
dispenser shell.
5. Replace the cover by lining
up the slot feature on the
inside of the cover with its
corresponding slot on the
housing assembly in order
to snap the cover back on.
Allow the cover to fall open
once replaced.
6. Insert the cable jack into the
module (cable shown in red).
7. See Module Installation Manual
for next steps to install.
for Recessed Dispensers
1.
3.
4.
6.
2.
5.
PH1
7.