Accessories; Fabric Brush - Rowenta IS6200 Mode D'emploi

ACCESSORIES

Before using an accessory, check the manufacturer recommendations.
It is also recommend that you carry out a test on part of the fabric which
cannot be seen.

Fabric brush

The fabric brush opens the weave of the fabrics for better steam pene-
tration.
Be sure unit is unplugged and completely cool before attaching
accesories.
• Attach the fabric brush to the steam head by lining up
the bottom of the brush with the bottom of the steam
head. Gently push the top of the brush onto the steam
head until it clicks into place.
• Gently brush the area to be steamed with the grain or
nap of the fabric.
• Remove the fabric brush once unit is unplugged and
completely cool. Remove it by pressing on the release
tab on top of brush while pulling it forward.
Crease attachment
• Remove the fabric brush. Completely slide the hook
of the accessory into the slot located in the lower part
of the steam head.
• Push on the handle to open the crease attachment.
• Place the garment between the crease attachment and
steam head.
• Release the handle.
• Starting at the top of the garment, move the crease at-
tachment in a downwards motion.
• Once unit is unplugged and completely cooled down,
remove the crease attachment by sliding it off of the
steam head.
13