Filling The Water Tank - Rowenta IS6200 Mode D'emploi

DESCRIPTION
1. Steam head
2. Steam head hook
3. Built in hanger
4. Trouser/dress clips
5. Hanger holder
6. Pole locking clips
7. Electric cord holder
8. Electric cord
9. Velcro strip
10. Telescopic pole
11. Pole fastening screw
GARMENT STEAMER ASSEMBLY
Pole and hanger assembly
1. Unscrew the pole's fastening screw on the base of the pole. (fig. 1)
2. Hold the pole such that the cord holder is on the left. Check that the 2
pole clips are unlocked. (fig. 2)
3. Insert the pole into the base by pressing downwards until the holes of
the pole and base are at the same level, so that you can put the screw
back. If the holes are not aligned, check that the clips of the pole are
well and truly unlocked. (fig. 3)
4. Screw the pole fastening screw back in as far as it will go so that the
pole is firmly fixed to the base. (fig. 4)
5. Push the hanger on the top of the pole vertically until you hear a click.
(fig. 5)
6. Adjust the pole to the height required by sliding it upwards then locking
the 2 clips. (fig. 6a, 6b)
7. Install the steam head between the hanger hooks.

Filling the water tank

IMPORTANT: Never use water that contains additives (starch, perfume, aro-
matic substances, softener, etc) in the steamer. Additives such as these can
affect the properties of the steam and lead to the formation of deposits.
• Ensure that the steamer is unplugged. Remove the water tank from the
base of the appliance by pulling the handle upwards (fig. 7). Unscrew
the tank cap and fill the tank. (fig. 8). Maximum capacity is indicated by
the "max" mark.
• The steamer must be used with TAP WATER. If the water in your area is
hard, Rowenta recommends that you mix half tap water and half distilled
12. Steam hose connector
13. Removable water tank
14. ON/OFF pedal
15. Transport wheels
16. Textile steam hose
17. On/ off light
18. Built in accessories
a. Fabric brush
b. Crease attachment
c. Lint pad
11