Hitachi NT 65MA4 Manuel D'instructions Et De Sécurité page 17

Push Lever
Trigger
● A nail will fi re each time the trigger
is depressed as long as the push
lever remains depressed.
(2) Continuous operation (Push lever fi re)
Using CONTACT
MECHANISM
● To avoid double fi ring or accidental
fi ring due to recoil.
1) Do not press the nailer against the
wood with excessive force.
2) Separate the nailer from the wood
as it recoils after nailing.
1 Set the switching device to the
downward position (to set to CONTACT
ACTUATION MECHANISM).
(Set the switching device to the
downward
shown in the diagram. Otherwise, it will
not operate properly.)
2 Pull the trigger with the Nailer off the
workpiece.
3 Depress the push lever against the
workpiece to drive a nail.
4 Move the Nailer along the workpiece
with a bouncing motion.
Each depression of the push lever will
drive a nail.
As soon as the desired number of nails
have been driven, remove fi nger from the
trigger.
3
4
WARNING
ACTUATION
WARNING
position completely
Previously pull the trigger
4
Push Lever
● Keep your fi nger off the trigger
except during nailing operation,
because
result if the push lever accidentally
contacts you or others in work area.
● Keep hands and body away from
the discharge area. This Hitachi
nailer may bounce from the recoil
of driving a nail and unwanted
as
subsequent nail may be driven,
possibly causing injury.
The SINGLE SEQUENTIAL ACTUATION
MECHANISM is for use where precision
fastener placement is desired.
The SINGLE SEQUENTIAL ACTUATION
MECHANISM may reduce the possibility of
bodily injury to you or others in the work area
compared to the CONTACT ACTUATION
MECHANISM. This is because it is less
likely to drive an unwanted nail if you keep
the trigger pulled and accidentally bump
the push lever against yourself or others.
English
1 Downward position
Switching Device
2
WARNING
serious injury could
17