Gewiss JOINON WALLBOX I-CON BASIC Manuel D'installation Et D'exploitation page 50

JOINON WALLBOX I-CON BASIC recharging unit for electric vehicles
50
There are two ways of adding more RFID cards to the local list:
METHOD 1
# Action to be carried out
Swipe the MASTER key across the RFID scanner to enable
1
the storage phase
Take each card that you want to add to the list and swipe
them across the RFID scanner.
2
The colour of the RGB LED indicates correct acquisition
To quit the RFID card storage menu, swipe the MASTER key
3
twice across the RFID scanner.
METHOD 2
# Action to be carried out
1 Disconnect the power supply to the product by turning off the main switch
2 Open the charging station to access the electronic board
3 Remove the microSD card from its slot on the electronic board
4 Insert the microSD card in the specific slot of your PC to open the folder
Create a .csv file called "RFID.csv".
The file structure must be:
UID1;
UID2;
5
Example
A14HNL5T;
DZ47TBD5;
....
6 Save the file in the main directory of the microSD card
7 Insert the microSD card in the slot on the electronic board again
Close the recharging station and reconnect the power supply to launch the procedure. If the procedure has
8 been completed without errors, the station will import the file and the data it contains. The LEDs will flash
blue, 3 times. At the end of the import procedure, the file will be renamed RFID_old.csv on the microSD.
9 Once the command has been executed, the station will return to standby
Contact GEWISS SAT customer service for the UID codes of your RFID cards; you will be asked to give the number
on the cards. 4-byte or 7-byte cards can be saved, as long as they are compatible with standard ISO/IEC 14443
part A
RGB LED status
From fixed green to flashing white
Fixed green for 2 seconds
From flashing white
to flashing red
to fixed green