Install The Door Control - Chamberlain B4603TC Manuel D'installation

Installation
STEP 9 Install the Door Control
To prevent possible SERIOUS INJURY or DEATH from electrocution:
Besure power is NOT connected BEFORE installing door control.
l
Connect door control ONLY to12 VOLT low voltage wires.
l
To prevent possible SERIOUS INJURY or DEATH from a closing garage door:
Install door control within sight of garage door, out of reach of small children at a minimum height of
l
5 feet (1.5 m) above floors, landings, steps or any other adjacent walking surface, and away from ALL
moving parts of door.
NEVER permit children to operate or play with door control push buttons or remote control
l
transmitters.
Activate door ONLY when it can be seen clearly, is properly adjusted, and there are no obstructions to
l
door travel.
ALWAYS keep garage door in sight until completely closed. NEVER permit anyone to cross path of
l
closing garage door.
INTRODUCTION
Older Chamberlain door controls and third party products are not compatible. Install door control within
sight of garage door, out of reach of small children at a minimum height of 5 feet (1.5 m) above floors,
landings, steps or any other adjacent walking surface, and away from ALL moving parts of door. For gang
box installations it is not necessary to drill holes or install the drywall anchors. Use the existing holes in the
gang box.
NOTE: Your product may look different than the illustrations.
Screw
6-32x1" (2)
Drywall
Anchors (2)
HARDWARE
Screw
6ABx1" (2)
Strip 7/16" (11 mm) of insulation from one end of the wire and separate the wires.
1.
Connect one wire to each of the two screws on the back of the door control. The wires can be connected
2.
to either screw. If your garage is pre-wired for the door control choose any two wires to connect, note
which wires are used so the correct wires are connected to the garage door opener in a later step.
Mark the location of the bottom mounting hole and drill a 5/32" hole.
3.
Install the bottom screw, allowing 1/8" (3 mm) to protrude from the wall.
4.
Position the bottom hole of the door control over the screw and slide down into place.
5.
Lift the push bar up and mark the top hole.
6.
Remove the door control from the wall and drill a5/32" hole for the top screw.
7.
Position the bottom hole of the door control over the screw and slide down into place. Attach the top
8.
screw.
1 2
7/16" (11 mm)
4-5
DRYWALL
GANG BOX
6-32x1"
Drywall Anchor
6ABx1"
7
22
3
6
8
DRYWALL
Drywall Anchor
6ABx1"
Wall
GANG BOX
6-32x1"