Wall Installation; External Antenna Installation - MyQ LiftMaster CAPAC Manuel D'installation

INTRODUCTION

Wall Installation

1. Drill (2) pilot holes, spaced 7 in. (17.78 cm) apart, on the wall where the device will be mounted.
INTRODUCTION
2. Use (2) #6 Phillips mounting screws (not included) to attach the device to the wall.
NOTE: For exterior mounting, LiftMaster recommends the use of a polycarbonate NEMA enclosure.
INTRODUCTION
OUTPUT WIEGAND INPUT
1 2 1
GATE OUTPUT
SDA SCL NO COM NC NO COM NC D1 COM D0

External Antenna Installation

For best cellular coverage position the antennas in the orientation
shown below (perpendicular to each other).
PRE-INSTALL
PRE-INSTALL
7 in. (17.78 cm)
PRE-INSTALL
2
WIEGAND INPUT POWER
D1 COM D0 1 GND 2 GND 12V-24V
POWER
INSTALL
INSTALL
INSTALL
ETHERNET
9
NETWORK ACCESS CONTROL
NETWORK ACCESS CONTROL
1.3 in. (3.3 cm)
NETWORK ACCESS CONTROL