Overview - MyQ LiftMaster CAPAC Manuel D'installation

INTRODUCTION

Overview

INTRODUCTION
INTRODUCTION
INTRODUCTION
Mounting Location
INTRODUCTION
INPUT/OUTPUT USED FOR
Relay Output 1 Gate Operator, Door Strikes, Maglocks, Lights (For control only. Power
to be provided by external power supply), Alarm Shunt
Relay Output 2
Wiegand Output 1 26-bit, 30-bit, 32-bit MiFare, 37-bit
Wiegand Output 2
Input 1 Closed Door Sensor (Supervised EOL or unsupervised),
Closed Limit Gate Sensor (Supervised EOL or unsupervised),
Input 2
Open Limit Gate Sensor (Supervised EOL or unsupervised)
NOTE: For UL installations, only UL 325 Listed gate operators, UL 294 Listed electric door strikes or
UL 294 Listed maglocks may be connected to relay output 1 or 2.
NOTE: For UL installations, only a Listed UL 294 access control unit may be connected to Wiegand
output 1 or 2.
PRE-INSTALL
PRE-INSTALL
LED Status Indicators
PRE-INSTALL
OUTPUT WIEGAND
PRE-INSTALL
1 2
GATE OUTPUT
SDA SCL NO COM NC NO COM NC D1 COM D0
PRE-INSTALL
INSTALL
INSTALL
Reset/Learn Button (back)
INSTALL
INPUT
INSTALL
1 2
WIEGAND INPUT POWER
D1 COM D0 1 GND 2 GND 12V-24V
INSTALL
5
NETWORK ACCESS CONTROL
NETWORK ACCESS CONTROL
External Antennas
NETWORK ACCESS CONTROL
NETWORK ACCESS CONTROL
POWER ETHERNET
NETWORK ACCESS CONTROL
Ethernet Port
Power Adapter Port
Mounting Location