Product Set Up - Nuna mixx2 bassinet Mode D'emploi

Product Set Up

Assembling the Bassinet Support Mounts
1
- Remove the mattress pad and rotate the attachment
mounts out from the center of the bassinet.
2
- Unfasten the hook and loop strips and lift the fabric
away from inside the bassinet to access the two support
mounts, which are located under the fabric at the canopy
and foot ends of the bassinet.
3
- Holding the top rail of the foot end, push the support
mount back to raise the end of the bassinet.
4
- Rotate the support mount down towards the latch at the
bottom of the bassinet as shown.
5
- Push the support mount into the latch on the bottom of
bassinet until it clicks into place. Repeat on the canopy
end of the bassinet.
6
- To fold, push button on the latch and pull support mount
out.
12 MIXX2 bassinet instructions
1
2
3
4
5
6
MIXX2 bassinet instructions 13