Trouble Shooting And Repair - Volpi Kamikaze KV4 Manuel De L'utilisateur

20. Trouble shooting and repair

Problem
The equipment
cannot be
started
Intermittent
running
Tying is not
successful,
tying effect
is not good.
Cannot charge
The red indicator
of charger is
blinking.
Possible reason
Battery is used up
Battery not inserted correctly
on/off switch failure
Internal connecting line is loose
on/off switch failure
After tying, it is loose and not firm;
Unsuccessful tying due to foreign
material
Incorrect or missing wire feeding
Tying is easily stuck by branches.
The battery is not placed in the
charger correctly.
The connection of charger and
power supply is not correct.
Battery voltage is too low
Battery failure
Charger failure
Corrective measures
Charge
Check the correct insertion of the battery in
the tool
Send to the Service Centre for repair
Send to the Service Centre for repair
Adjust gear switch to a suitable level
Check if there are any foreign matters in
feeding track, clear up foreign matters
and unsuccessfully tied tying wire.
1.Check if the tying wire is stuck in feeding
tray, if it is stuck, conduct cleaning
timely.
2.Check if there are any residual tying
wires or other foreign matters in the
whole feeding track, and conduct
cleaning timely.
1.Operation may be too fast, please adjust
operation speed. Only after confirming
the completion of tying action the tying
machine can be lifted up.
Verify battery to charger connection
Verify correct connection of charger to
power supply
Wait for 10 minutes.
Replace battery
Replace battery charger
45