Volpi Kamikaze KV4 Manuel De L'utilisateur page 30

•
When operating the tool, always hold it with one hand, and keep a distance of at least 5cm away
from the other hand and your whole body.
•
Feeding system must be checked and cleaned frequently. If foreign matters are accumulated in the
feeding track, it will affect tying effect and increase load to the equipment. Quality assurance does
not include the damage caused by the wrong maintenance mentioned above.
•
Do not attempt to repair the tool yourself. Repair operations not mentioned in this manual can
only be performed by the personnel of our service center.
•
Use only the wire suggested by the producers. The usage of other wire will invalid the warranty of
the tool.
4.3 Special safety instruction for battery tool
•
Make sure the battery compartment (12) is clean, dry and that the internal contacts are in perfect
condition before inserting the battery (13). Check the correct position of the same before insertion.
•
Charger design for use only indoor. Charging operations have to be performed indoor.
•
Disconnect power before to clean the charger to avoid damage and risk of electrical shock; carry
out the operation with a dry cloth.
•
Don't expose battery in strong light. Don't put battery on hot surface. It can cause battery
explosion.
•
Recharge the battery when the display (7) indicates that it is at charge level 1.
•
Don't disassemble the battery, don't damage battery, in order to avoid injury.
•
Do not store the machine with the battery (13) inserted in the handle (12). The battery (13) must
be recharged at least every 3 months to avoid damaging it. The warranty does not cover damage
caused by failure to comply with the recharge frequency.
4.4 Use charger correctly
•
Use the charger only with rechargeable battery. If not it can cause fire or explode. Use original
charger to keep safety.
•
Always check charger, wire and plug before use. If damaged, please move to Customer Assistance
Service to repair. Don't use damaged charger, don't repair by yourself, this will keep the tool safe.
•
Check voltage of charger match the battery value, if not may injury yourself.
•
Keep charger clean, away from drippy or rain environment. Don't use the charger outdoor, dirt or
water can cause injury (see technical characteristics section).
•
Properly disconnect the charger from the outlet, do not pull the cables and do not leave the
charger plugged in once charging is complete.
•
The charger is designed for original battery only. Otherwise may be cause damage or fire.
•
Avoid damaged charger will reduce injury.
•
Don't use chargers on tinder surface (e.g. paper or dry goods).
•
The battery is not fully charged when you buy it, you must charge 3 / 4 hours before first use the
tool. Connect the battery to charger before power on.
•
Normal charging time is 3 / 4 hours, don't charge the battery for too long time, it will damage the
battery.
•
The charger has three outputs, you can charge up to 3 batteries simultaneously (2 + 1 additional or
optional). The charging time is proportional to the number of batteries connected and the state of
their charge. Monitor the charging time by the LED indicator (red light in charge, green light end of
charge).
30