Cleaning And Maintenance - Volpi Kamikaze KV4 Manuel De L'utilisateur

3 - Insert the thread press carriage and place the
front cover correctly. The tool can now
continue to work with the new thread.

15. Cleaning and maintenance

Before to start any cleaning or maintenance operation, switch off the machine and
disconnect the battery to the machine. Place battery in a safe package.
• Cleaning and maintenance must be carried out regularly to ensure the long-term and reliable
operation of the equipment.
• Don't spray water on the equipment or immerse it in water, otherwise the equipment will be
damaged.
• Keep ventilating slot, engine chamber, and equipment handle clean. It shall be cleaned with a
wet cloth or a hair brush. Don't use any cleaning agent; otherwise it may cause permanent
damage to the equipment.
• Each time after one roll of tying wire is used up, please use tweezers or a brush to clear up
foreign matters in wire track.
• After continuing working for 8 hours, use tweezers or a brush to clear up foreign materials in the
wire track. Check if the pin, retaining ring, and spring of each movable joint have any foreign
material, if there is any foreign material, remove it immediately.
• Fill sufficient lubricating oil at cutter and each joint.
• Good maintenance habit can extend the service life of the product effectively.
• Wire track cleaning operation shall be performed according following procedure:
41