Technical Description; Setting Up And Initial Operation; Technical Data - Denios 181090W Mode D'emploi

4. Technical Description

The drum lifter has 3 wheelbase options and two lifting options:
Servo Type
Wheelbase
Overall height (mm)
Lifting range (mm)
Lifting equipment
The Servo Drum lifter is constructed as follows:
- Stable frame with I lifting mast
Turning, pivot-mounted prism jaws with safety strap (Ex version in anti-static design)
-
Hydraulic pump with lifting cylinder or crank handle with cable winch-
Gear drive with hand wheel
-
2 fixed castors and 2 swivel castors (for the Ex version in electrically conductive design).
-

5. Setting up and initial operation

Drum lifter with hydraulic pump:
Before using the drum lifter for the first time, loosen the oil screw on the hydraulic
cylinder and raise the lifter with a load on board so that the air is removed from the
hydraulic system. Afterwards tighten the oil screw again. This method can also be
used for removing any air bubbles in the hydraulic system in the future.
If the oil screw is replaced with a screw with a hole (possibly included in the
delivery), the hydraulic system is permanently bled.
Adjust the adapter plate to suit the drum gripper
By changing the adapter plate the drum lifter can be adjusted to suit various starting heights and so the "no
load lift distance" (the amount the lifter is raised before the drum is lifted) can be reduced.
To do this, loosen the safety screws above the attachment holes (A or B) and then hang the adapter plate on
the frame at a different height. Now set the new attachment position using the safety screws.
Adapter plate attachment position
Regularly check the safety screws and if necessary tighten them.

6. Technical data

Maximum load: 300 kg
Permitted operating temperature / ambient temperature: -10°C to 40°C.
184360_BA_INT_008 Fasslifter Servo mit Prismengreifer
181088, 181090, 115293, 115295
181089, 181091, 147723, 147722
FW 8-
narrow
1540
120 - 750
with hydraulic pump
Safety screw
B
A
FW 12
wide
1540
0 - 750
with hydraulic pump
Seite 11 von 33 Seiten
FW 16-F
wide
2130
0 - 1400
with hydraulic pump
FW 16-H
wide
2130
0 - 1400
with cable
winch
Ausgabe 09/2015