Centronic Dirt Devil M2615 Instructions D'utilisation Et Consignes De Sécurité page 73

3 Operation
4
3
2
1
Fig. 10
Fig. 11
1
Fig. 12
1
Fig. 13
1. Attach the desired nozzle
Chapter 2.3, "Using further nozzles (accessories)".
2. Pull out the cord by the plug up to the yellow mark
(Fig. 10/1).
WARNING:
Danger of electric shock! If the red marking (Fig. 10/2)
shows, retract the cord by pressing the cord retracting
button (Fig. 10/3) to pull in the cord up to the yellow mark
again. Otherwise the power cord might break.
3. Insert the mains plug into a socket with ground/safety
contact.
WARNING:
Danger of injury or fire! Only operate the appliance if your
mains voltage is the same as that indicated on the appli-
ance's type plate. Wrong voltage can cause short-
circuiting and possibly a subsequent fire.
4. Switch on the cylinder vacuum cleaner with the on/off
switch (Fig. 10/4).
A
5. Set the nozzle switch to "carpet" or "hard floor" accord-
ing to the floor (Fig. 11) to be cleaned:
- hard floor (Fig. 11/A):
B
for laminate, tiles, PVC, etc.
- Carpet (Fig. 11/B):
for carpets, runners, etc.
6. Set the suction power with the suction power control
(Fig. 12/1).
7. When working with the vacuum cleaner, pull if after you
like a sleigh.
NOTE:
In normal situations the bypass vent (Fig. 13/1) must be
completely closed. With the bypass vent you can quickly
reduce the suction power, e.g. to release curtains that
have accidentally been sucked in.
Chapter 2.2, "Assembly" or
GB
73