Assemble The Enclosure; Ventilation Requirements - Norcold N10DCX-10 Manuel D'installation

Assemble the Enclosure

Make sure that the enclosure is the correct size:
- For N10DC models – 59.88 – 60.01 inches high x 23.50 – 23.63 inches wide x 24.00 inches deep.
Make sure the floor is solid and level:
- The floor must be metal or a wood panel and extend the full width and depth of the enclosure.
- The floor must be able to support the weight of the refrigerator and its contents.
Make sure there are no adjacent heat sources such as a furnace vent, etc.
Make sure any exterior vents are blocked.

Ventilation Requirements

This refrigerator is made for a built-in installation. Correct ventilation is necessary for the correct operation of the refrigerator
and to increase the life of the refrigerator cooling system.
Ventilation allows the natural air flow that is necessary for good refrigeration. Cooler air comes in under the refrigerator, goes
around the refrigerator coils where it removes the excess heat from the refrigerator components, and goes out through an
upper exhaust vent. If this air flow is blocked or decreased, the refrigerator will not cool correctly.
!
CAUTION
The refrigerator has a built-in vent at the top and clearance at the bottom. Make sure that the flow of air through
these vents is not blocked in any way. Blockage of air through these vents can cause:
- shortened life of the refrigerator cooling unit.
- poor cooling performance of the refrigerator.
- continuous operation of the refrigerator.
- fast battery discharge.
- void of the refrigerator warranty.
Installation Manual 3