Table Des Matières; Meanings Of Signal Words; Important Safety Information; Intended Use - Flex L 12-3 100 WET Notice D'utilisation

L/LE 12-3 100 WET
CONTENT
MEANINGS OF SIGNAL WORDS . . .3
IMPORTANT SAFETY
INFORMATION . . . . . . . . . . . . . . . . . 3
GENERAL POWER TOOL SAFETY
WARNINGS . . . . . . . . . . . . . . . . . . . . .4
WET POLISHER SAFETY
WARNINGS . . . . . . . . . . . . . . . . . . . . .6
TECHNICAL SPECIFICATION . . . . . .8
OVERVIEW . . . . . . . . . . . . . . . . . . . . 9
OPERATION . . . . . . . . . . . . . . . . . . .10
MAINTENANCE . . . . . . . . . . . . . . . .15
SERVICE AND REPAIRS . . . . . . . . .15
WARRANTY . . . . . . . . . . . . . . . . . . .16
MEANINGS OF SIGNAL
WORDS
DANGER
DANGER indicates a potentially
hazardous situations which, if ignored,
could result in death or serious injury.
CAUTION
CAUTION indicates a potentially
hazardous situations which, if not
avoided, may result in minor or
moderate injury, or may cause machine
damage.
! NOTE
NOTE emphasizes essential
information.
IMPORTANT SAFETY
INFORMATION
Read and understand all of the safety
precautions, warnings and operating
instructions in the Instruction manual
before operating or maintaining this
power tool.
Most accidents that result from power
tool operation and maintenance are
caused by the failure to observe basic
safety rules or precautions. An accident
can often be avoided by recognizing
a potentially hazardous situation before it
occurs, and by observing appropriate
safety procedures.
Basic safety precautions are outlined in
the "SAFETY" section of this Instruction
manual and in the sections which contain
the operation and maintenance
instructions.
Hazards that must be avoided to prevent
bodily injury or machine damage are
identified by WARNINGS on the power
tool and in this Instruction manual.
NEVER use this power tool in a manner
that has not been specifically
recommended by FLEX.

INTENDED USE

The FLEX L/LE 12-3 100 WET wet stone
polisher
- is designed for industrial
applications,
- is designed for wet polishing
applications,
- is intended for surface work with
natural stone and concrete,
!
- should only be fitted with suitable
accessories. These can be polishing
or buffing pads and abrasive discs.
Instruction manual
3