dji SNAIL 6048-3D Guide De L'utilisateur page 6

2. Remove the cap on the Snail Propeller Adapter.
3. Align the holes of the black Propeller Adapter with the holes on the CW
motors. Insert the M2×4 screws and tighten to secure. Align the holes of
the red Propeller Adapter with the holes on the CCW motors. Insert the
M2×4 screws and tighten to secure.
4. Install the unmarked propellers onto the red Propeller Adapter, and install
the propellers marked with CW onto the black Propeller Adapter.
5. Secure the propellers by rotating the red cap onto the axes of the red
Propeller Adapter and black cap onto the axes of the black Propeller
Adapter.
Using 6048-3D Propellers installation as an example.
Before mounting the 6048-3D propellers, select 3D Mode in DJI
Assistant 2 and update the corresponding firmware.
Stand clear of the motors and DO NOT touch the propellers when
they are spinning.
DO NOT mix propeller types.
4