Controls And Instruments; Model Identification; Operating Instructions; Starting And Stopping The Engine - GOLDONI SUPER SPECIAL Serie Emploi Et Entretien

19. The operator must check to be certain that every part of the tractor and,
especially the safety devices, are in good working condition and work to
specs. They should be kept in perfect working condition. If you note any
malfunctioning, fix or repair them in good time. If necessary contact your
nearest Assistance Centre. Failure to observe these instructions releases
manufacturer from all liability.
Pay special attention to the stickers on the machine.
Fig.9: refer to this Operating and Maintenance Manual

2. CONTROLS AND INSTRUMENTS

See fig.1
1 Handlebar adjusting lever
2 Left brake lever
3 Right brake lever
4 Gear change lever
5 Engine throttle lever
6 Bottom PTO lever
7 Engine stop lever (motorstop)
8 Clutch lever
(fig.2)
1 Decompression valve lever (models where it is included)

3. MODEL IDENTIFICATION

Model, Series and Chassis Number are machine identification data. They are on
a specific plate on the accessory box.

4. OPERATING INSTRUCTIONS

4.1 STARTING AND STOPPING THE ENGINE

To start the engine, lock the Motorstop n.7 fig.1 in its fully lowered position, pull
in the clutch lever C fig.2 and insert retainer A under the lever so that the clutch
is kept disengaged. This locks the two levers in position to prevent starting the
engine with a gear engaged.
Start the engine following the instructions given in the engine Operating and
Maintenance Manual.
Check to be sure that the gear lever n.4 fig.1 and the PTO lever n.6 fig.1, are in
neutral.
Pull in the clutch lever again to disengage the retainer A so that both the
Motorstop and the clutch lever are operative.
38