Product Overview; Default Settings - Velux INTEGRA KLF 200 Manuel D'installation Et Mode D'emploi

Product overview

Default settings

Product overview
1 Light-emitting diode
2 ETHERNET/service
(for internal use only)
3 Power supply
4 Key button
5 RESET
6 Outputs
7 Inputs
Default settings
Inputs (control)
An external control signal shorter than 1.5 seconds makes the VELUX
product travel to end position.
• Odd inputs (1, 3, 5, 7, 9) are used for open/up
• Even inputs (2, 4, 6, 8, 10) are used for close/down
An external control signal longer than 1.5 seconds makes the VELUX
products travel until the signal stops or until the product has reached end
position.
Default speed is used for all skylight operators including those supporting
silent mode.
Outputs (signals)
The output relay is activated for 2 seconds when an action has been suc-
cessfully executed.
The default settings can be adjusted by using the web interface.
See enclosed supplementary instructions
ENGLISH
2
3
4
5
.
B
1
6
7
7
VELUX 7
®