Function As Repeater; Registration With Velux Active Gateway 3Lg - Velux INTEGRA KLF 200 Manuel D'installation Et Mode D'emploi

Function as repeater

Registration with VELUX ACTIVE gateway 3LG

The repeater function extends the operation
range of two-way gateway 3LG by transmitting
received wireless commands. When used as a
repeater, KLF 200 is therefore to be placed ap-
proximately halfway between the gateway and the
io-homecontrol
®
Note: The repeater function cannot be used with
one-way wall switch KLI.
Registration with VELUX ACTIVE gateway 3LG
KLF 200 is registered with gateway 3LG by using
the gateway buttons only.
Note: KLF 200 does not extend the range of
VELUX ACTIVE sensor and departure switch.
1
5 sec
24 VELUX
®
products to be operated.
Press the RESET button on
the back of KLF 200 for
5 seconds with a pointed
object until the diode emits
red light. Subsequently, the
diode flashes yellow.
ENGLISH