Quick Start Programming; Full Programming Options - Memco Memcom+ Guide D'installation

Full Programming Options

Quickstart >
Tel. Numbers >
Alarm no. 1
Alarm no. 2
Alarm no. 3
Alarm no. 4
Tech.no.
Background no.
Call attempts
Settings >
Codice ID
Volume
Accessories >
System Config >
System Config+ >
HW Monitoring >
Lift Monitor
IP1 only
iP1+iP2 (Serv.)
Service Count
Interval
Live Count
Delays >
COP delay
MPS delay
TOC delay
Tech IP1 delay
Tech IP2 delay
Hangup delay
Answer delay
Messages >
Location
Reassurance
Guidance
Time / Date >
Time
Date
Advanced >
Passcode
Network ID
Next EN81 call
PBX Frequency
Language
Relay Mode
Relay Override >
HW Config >
GMT Offset
DTMF RX
Menu Sections
Quick Start
The quick start menu consists of 7 menu options required for quick
setup. Please refer to the previous page in this guide for more
information.
Tel. Numbers
Alarm no.
Up to four alarm telephone numbers can be programmed in the
Memcom unit.
+
Using the keypad, enter the first alarm telephone number.
When using a Hotline, enter the telephone number as 0.
Select a protocol required from this list.
Guided Voice
Unguided Voice
Memco
P100
Hotline
Contact ID
Scroll to the preferred protocol and press # to confirm.
Note: When connecting to a PBX/PABX, insert the number required to
get an outside line, followed by a pause (*), followed by the telephone
number. i.e.. 9*01344854000
If further alarm numbers are required, repeat this process for Alarm No.
2, Alarm No. 3 etc.
Tech. no.
The Memcom
system.
A Technical alert is a non-scheduled event e.g. from a Technical Input or
low battery with no main power.
All other diagnostics are checked during a scheduled Background Call
(see below). As standard this number is attempted the number of times
indicated by the 5th digit in Call Attempts (see below Call Attempts)
screen before waiting for the next technical alarm.
If using Avire ETR software select the 'Memco' protocol.
Background no.
To set up the EN81-28 three day test call (background test call)
programme the required telephone number here.
If using Avire ETR software select the 'Memco' protocol.
Call Attempts
>
The number of attempts the Memcom
>
telephone number (maximum is 9 attempts per number).
The default is '999999'; each digit identifies one of the six programmed
telephone numbers.
Unit will play a Guidance Message (see page 10) to the call centre when
answering an alarm call
No message is played when a alarm call is answered.
NOTE: If 'Auto Location' has been selected in 'System Config+' then the
location message WILL automatically play at the start of the call.
Protocol required if receiving background test calls with ETR
Protocol required if receiving background test calls with P100 receiver
software
Use if setting up as a hotline
Protocol required if receiving background test calls with 'Contact ID'
receiver software
+ can place Technical alert calls to signal faults with the
+ will make to contact each
6