Memco Memcom+ Guide D'installation page 4

Quick Start Guide
Language Selection
The first time the Memcom unit is
+
powered up, it will automatically
load the language selection. Using
the up and down arrows scroll to the
required language and press #.
Once you have selected the correct
language the Memcom will load the
+
Quick Start menu, which is mapped
out to the right.
Menu Controls
Scroll up
Scroll Down
#
Forward / Accept
*
Back / Cancel
S imply follow the quick start guide
on this page to set up the essential
programming of the unit.
If you require details of the full menu
structure available then please refer
to pages 6-12 of this guide.
ETR
Using Memcom + ETR software (free
of charge), users can set up and
maintain their own database of lift
emergency telephones. The software
can be used to receive emergency
calls, test calls and equipment
monitoring for over 5,600 lifts per
system. Additionally, the software
can remotely program the telephone
units, saving time and money and
reducing the number of site visits
required.
Technical Support
If you require any further assistance
when programming the Memcom
unit, please call our Technical Service
Team on 01628 540160.
Quick Start Menu Process Guide
Step 1
Alarm No 1
Step 2
Tech. No
Step 3
Background No.
Step 4
Accessories
Step 5
Volume
Step 6
Location
Step 7
ID Code
Step 8
Network ID
You have now finished the essential programming, If
you are in an option, press * to return to the Quick Start
Menu. Then, to exit programming mode Press * and
select the action required upon exiting from this list.
+
+ Using the keypad, enter the first alarm
telephone number.
+ Select the protocol required from the list
which includes Guided, Unguided, Memco,
P100, Hotline and Contact ID.
+
Using the keypad, enter the telephone
number of the software system for Technical
calls.
+
Select the protocol required from the list.
+ The unit will ask if you want to use the same
number for background calls, press # to
accept and * to reject.
+ If you have accepted to copy the telephone
number from the Tech No, you can skip this
option
+ If not, enter the telephone number required
+
Select the protocol required from the list
+ Select the accessories you have attached to
the unit by pressing # to select / deselect
each option
+ If you require a volume different to the
default volume, press the up and down
arrows until the desired volume is reached
+ Press # to confirm
+ To record a Location Message, press 2 to
start recording
+ Press # to end the recording
+
Press 1 to play the message back
+ Only requires input if you are using GlobalNet
to monitor the Memcom unit
+
If so, add 3 digit Globalnet number to unit ID
code, which is written on the bottom of the
unit, i.e., 109 463768
+ If you are attching more than the one
Memcom unit to a single telephone line, you
need to assign each unit a network ID
+ The first unit would have an ID code of 1, the
second unit 2, the third unit 3 and so on.
4