Memco Memcom+ Guide D'installation page 5

Testing and Operating Mode
The status of the unit is shown on the top row of the idle
screen. If there are no faults, it will display 'Status OK'.
Status OK
1:Programming
If a GSM unit is connected, the antenna signal strength
symbol will be shown to the right of the "Status OK" text.
Menu Controls
Scroll up
Scroll Down
Enter the option number required
*
Back / Cancel
You can use the up and down arrow to navigate through
the options. Enter the option number to enter that option.
Menu Structure
Status OK
1:Programming
2:Call Log
3:Event log
4:Service Count
5:System Info
Displays the current system information for fault
diagnostics
Fault Detected
If a fault is detected, then '6: Fault Log' will flash on the
top row of the idle screen, as below. pres 6 to view the
fault log.
6:Fault Log
1:Programming
Alarm activated – End of Alarm
If the alarm state is activated i.e. an alarm call has been
placed. The unit will remain in alarm state until the 'End of
Alarm' is activated. Press 7 to end the alarm.
7:End of Alarm
1:Programming
1. Programming
Press 1 to access the standard programming menu.
Old Programming Mode – to program the Memcom
using the Old Menu (code based) programming options,
simply press * followed by the passcode for the unit and
confirm by pressing # (default- *1234#) from the Idle
screen. A map of this menu is displayed on page 12 of this
document.
2. Call Log
Displays the last 10 call events logged by the unit.
3. Event log
Displays the last 10 events for the unit.
4. Service Count
Displays service count information if active.
Recent count is:
00000000
Service Due in:
00000500
Total Count is:
00000000
Overdue by:
00000042
5. System Info
Displays the current system information for fault
diagnostics.
FF.ff AAAAbcd
SS.ssV BB.bbV
UT:0000d00h00m
RT:HHMMSS DDMMYY
Ax Ex Fx SCx Sx
Yx Gx Rx GSMy
6. Fault Log
Displays information on all active faults – gives time and
date and fault mode.
6:Fault Log
1:Programming
7. End of Alarm
Allows the alarm state to be reset. The message "7:End of
Alarm' will flash on the top row of the idle screen until the
7 key is pressed to reset it.
7:End of Alarm
1:Programming
Installation and essential programming are now complete,
please refer to Full Programming Options section on the
following pages of this guide if further programming is
required.
unit
+
5