Using The Sweeper; Manual Operation - Haaga 475 Mode D'emploi

5 Using the sweeper

5.1 Manual operation

1. Check the sweeper
(see Maintenance and care).
2. Adjust the sweeper
(see Adjusting the sweeper).
3. Guide the push handle with both
hands.
4. Push the sweeper forward at normal
walking pace.
5. Empty the waste bin as required
(see Emptying the waste bin).
5.2 Adjusting the sweeper
Height adjustment
NOTE
• Do not press the disc brushes onto the
ground too firmly.
• An excessive contact pressure will not
achieve a better cleaning result but will
increase the wear.
• An excessive contact pressure will
increase the pushing resistance.
NOTE
The knob for height adjustment of the
disc brushes is located in the middle
of the front section. The height adjust-
ment knob allows the height of the disc
brushes to be adjusted to the ground to
be swept.
1. Adjust to the required level (1):
• Level 1 – 2: for all flat, hard surfaces
(e.g. asphalt, concrete, slabs...)
• Level 3 – 4: for damp leaves, sand,
uneven surfaces
(e.g. washed concrete slabs)
• Level 5 – 8: for heavy soiling and very
uneven surfaces
2. To do this, turn the knob (2) anti-clock-
wise or clockwise to the desired posi-
tion.
1
Adjusting the brush
holding-down device: 477 / 497
NOTE
The brush holding-down device adjusts
the right disc brush to the edge areas to
be swept, e.g. walls or kerbs.
Excessive wear can occur in the event of
unsuitable adjustment at lower edges.
The holding-down device must not scrape
on the ground.
2
31