Publicité
Les langues disponibles
Les langues disponibles
INSTRUCTION FOR USE
EN
Storage
VarseoWax Model must be stored in the original sealed bottle at room temperature
(approx. 22 °C) in a dark, dry place. It must be ensured that the temperature does not
drop below +5 °C and does not exceed +35 °C! The minimum shelf life date printed on the
product must be observed. Perfect processing cannot be guaranteed if materials which have
exceeded their minimum shelf life date are used.
6. Processing
VarseoWax Model is one of the system components in the BEGO Varseo 3D print system and
has been optimised for use in the Varseo 3D printer. The printing settings can be found in the
instructions for use for the respective equipment. For further information on waxing up and
processing, please refer to the guidelines on the production of models using the 3D printing
method*.
Please wear protective gloves (nitrile gloves), protective clothing, goggles and / or face
protection during processing!
The ideal working temperature range for VarseoWax Model is between 20 and 30 °C. The
material must be shaken thoroughly for approx. 5 min before being poured into the clean
Varseo container. If not shaken sufficiently, this can lead to inhomogeneities within the
model and / or to deviations in the colour of the model or dies. When decanting, make sure
that the printing resin is exposed to daylight for as short a period of time as possible.
For further processing – selecting the resin, setting up the print job – as part of the printing
process, follow the respective Varseo printer instructions for use. Before starting any printing
procedure, VarseoWax Model must be mixed so as to form a homogeneous mixture. Before
each print job, check that there are no solids (fillers) on the cartridge film. Deposited solids
can have a detrimental effect on the printing results. The resin can be stirred using the blank
cards from BEGO (REF 19551). Alternatively, a silicone spatula can also be used. Avoid
using sharp objects such as metal spatulas in order not to damage the film!
Subsequent processing
On completion of printing, the print objects are detached from the build platform by
actuating the ejector** and / or using the spatula supplied. The print object should be cleaned
in two steps with ethanol (96 %) using an ultrasonic bath.
Note: Never fill ethanol directly into the ultrasonic bath; place it in the recommended
container (REF 19621) in the ultrasonic bath filled with water. Use an explosion-proof
ultrasonic bath.
* The waxing-up software shown as an example in the guidelines is 3Shape; useful tips for exocad users can be found in the
"exocad wiki" at wiki.exocad.com
** Varseo and Varseo L cartridges
Publicité
