Publicité
Les langues disponibles
Les langues disponibles
STEP 1 – INSTALL THE BATTERIES
1. Loosen the battery door screw using a Phillips head screwdriver.
2. Insert the included CR-123 batteries using the battery orientation
markings on the side of the light.
3. Re-install the battery door screw until tight. CAUTION: Do not
over-tighten.
STEP 2 – INSTALL THE TWM ONTO YOUR HANDGUN
NOTICE: Your TWM has been pre-configured with the universal
Cross Rail Insert which will fit approximately 70% of the handguns on
the market. If the fit is not correct for your specific handgun, use the
included Allen Wrench to relocate the Insert to the slot location that
works best for your firearm.
1. Push inward on the Rail Clamp Tension Thumbscrew fully
spreading the moveable rail clamp.
2. Align the Cross Rail Insert with the appropriate slot on the
tactical rail of your handgun and then rotate the rail clamp sections
of the TWM onto your handgun's rail so that the Insert is fully seated
in the slot.
3. While making sure that the insert remains fully seated in the
slot, hand-tighten the Rail Clamp Tension Screw.
4. Use a quarter to fully tighten the Rail Clamp
CAUTION: PERIODICALLY CHECK THE CROSS RAIL INSERT
SCREWS AND THE RAIL CLAMP TENSION THUMBSCREW FOR
TIGHTNESS.
Bayco Products, Inc. • 640 South Sanden Blvd. • Wylie, TX 75098 • 1-800-233-2155 • 1-469-326-9400 • www.nightstick.com
QSG-TWM-350/850-18b
Tension Screw.
Publicité
