NightStick TAC-302B-K01 Mode D'emploi

Instruction Manual
TAC-302B-K01
Thank you for selecting the Nightstick Varmint Hunter
Green LED Light Kit.
SAVE THESE INSTRUCTIONS
Please read these instructions before using this product. They include
important safety and operation information.
WARNINGS
• NOT FOR USE ABOVE HAZARDOUS LOCATIONS
• DO NOT use in explosive atmospheres, near flammable liquids, or where
explosion proof lamps are required.
• DO NOT use in the proximity of vehicles or equipment when there is a risk
of flammable liquids coming into contact with the flashlight.
• DO NOT expose the batteries to water or salt water, or allow the batteries
to get wet.
• DO NOT store the batteries with metallic objects that may cause a short
circuit.
• Immediately discontinue use of the batteries if they emit an unusual smell,
feel hot, change color, change shape or appear abnormal in any way.
• Keep out of the reach of children.
PRODUCT OVERVIEW
The Nightstick Varmint Hunter Green LED Light Kit contains all of the
components needed to add a high-power Green LED flashlight to any long
gun equipped with a mil spec Picatinny or Weaver rail. The included remote
pressure switch provide momentary on/off control over the light.
PERFORMANCE INFORMATION
The TAC-302B flashlight is rated at 150 lumens with a beam distance
rating of 180 meters. Powered by the two included CR-123 Lithium batteries,
the light will nominally operate for 3.5 hours.
INCLUDED ITEMS
Bayco Products, Inc. • 640 South Sanden Blvd. • Wylie, TX 75098 • 1-800-233-2155 • 1-469-326-9400 • www.nightstick.com
ASSEMBLY INSTRUCTIONS
The TAC-302B Varmint Hunter Green LED flashlight comes with the
pocket clip and the tail cap switch already attached. As such, the light can be
used right out of the packaging as a conventional Green LED flashlight once
the included CR-123 batteries are installed. This light may be converted back
to this configuration at any time.
Steps necessary to assemble the Nightstick Varmint Hunter Green LED Light Kit
1. Remove the Pocket Clip (Figure 1-B) by unscrewing and removing the
Light Bezel (Figure 1-A).
2. Once the Pocket Clip has been removed, reinstalled the Light Bezel
(Figure 1-A).
3. Next remove the Tail Cap Switch (Figure 1-C). NOTE: Keep the Tail Cap
Switch and Pocket Clip for future use if this light is to ever be converted back
to a conventional Tactical Flashlight.
4. Next install the two included CR-123 Batteries (Figure 2-A). The positive
terminals on each battery should be oriented in the direction of the Light
Bezel.
5. Install the Remote Pressure Switch (Figure 2-B) and tighten into place.
6. Next test the operation of the Remote Pressure Switch (Figure 3-C) and the
Side Switch (Figure 3-D). The Remote Pressure Switch provides Momentary
INS-T302B-K01-18