Publicité
Les langues disponibles
Les langues disponibles
Programming the X10 address and the various options
The chart below shows the various possibilities to program the
MicroModule LWM1
Factory defaults
Address A1
Doesn't respond to
"All Lights On"
Doesn't respond to
"All Off"
Connected switch is a
2-face momentary switch 1-face momentary switch 2x Bright
For programming the Marmitek X10 address and options you will
be able to use any Marmitek X10 controller or remote control,
apart from the CM11 computer interface.
For the following explanation we used a Marmitek 8-in-1 remote
control to program the preferred settings (when you use an RF
remote control like the Marmitek 8-in-1, then a TM13 Plug-in
Transceiver is required to convert the RF signals to the X10
commands through the power line).
Sample 1. Program the Marmitek X10 address E4:
• Setup your remote control (see manual 8-in-1) and the TM13
transceiver to house code E.
• Start with the MicroModule in setup mode.
• Press the Marmitek X10 button (marked with the symbol of a
house) of the 8-in-1 remote control and then press button 4.
• Press the "ON" button 2x (= channel+).
• The MicroModule responds by blinking the LED twice.
• The address E4 is programmed.
• If you wish to program more options, you have to make sure
the module remains in setup mode.
8
Programmable
Address A2 .. P16
Responds to
"All lights On"
Responds to "All Off"
Connected switch is a
Command
2x Address
2x All Lights On 6x
2x All Off
MARMITEK
Light blinks
2x
8x
12x
Publicité
