Publicité
Les langues disponibles
Les langues disponibles
Programming
WARNING: DO NOT FORGET TO TURN ON THE MAIN MASTER
SWITCH PRIOR TO PROGRAMMING.
Activate the setup procedure.
The following steps have to be taken to start the setup procedure
for programming the MicroModule:
• Press the setup (prog.) button for at least 3 seconds.
The LED should stay on after releasing the setup button.
• Warning! The MicroModule will leave the setup mode if it
doesn't receive any commands within 60 seconds.
Exit setup mode
• Press the setup button once shortly. You can also wait for at
least 60 seconds so that the MicroModule will exit the setup
mode automatically.
Activate or exit the setup mode
MICROMODULE LWM1
7
Publicité
