Marmitek MicroModule LWM1 Mode D'emploi page 6

Mounting Instructions
WARNING! ALWAYS SWITCH OFF THE MAIN MASTER SWITCH
BEFORE INSTALLING THE MICROMODULE.
To install the MicroModule LWM1 the following wiring is required
at the module installation point.
Neutral
Phase 230V
Load.This wire runs directly to the load.
• Take the wall switch out of the wall outlet.
• Disconnect all wires from the switch.
• Pull an additional N-wire in case this one is missing.
• Connect the phase, neutralize and load wire to the terminals
of the MicroModule LWM1.
• Connect the thin wires of the built-in module to the wall
switch. See "Explanation about connecting switches" for more
information.
• Position the MicroModule against the back wall of the wall
outlet behind all the wires.
• You are now able to program the MicroModule. For more
information see chapter "Programming".
• Install the wall switch at its original place after the
MicroModule is programmed.
6 MARMITEK