Installation - Craft Meyer 10031479 Mode D'emploi

CAUTION!
Risk of slipping, stumbling and falling!
• Maintenance work on the raised vehicle and the use of cleaning agents, care
products and lubricants can result in a risk of slipping and falling and the
resultant injuries.
• Beware of projecting parts and eradicate any stumbling hazards.
IMPORTANT!
Risk of damage!
• Improper handling of the lift stand can lead to damage to the lift stand or
damage to the vehicle.
• During use, place the lift stand on a scratch-resistant surface with sufficient
load-bearing capacity and make sure that there is sufficient space in a non-
explosive atmosphere.
• Only use the lift stand with the original accessories.
• The lift stand must not be loaded with more than a maximum of 150 kg.
• In order to prevent injuries and damage, make sure that the work station is well
lit.
• Do not wear loose-fitting clothing as there is a risk of being caught on
projecting parts. Therefore, only wear close-fitting clothing. Never wear rings,
chains or other jewellery. Persons with long hair must wear a hair net. Wear
sturdy shoes or work safety shoes.

5 | Installation

6
The Craft-Meyer Lift Stand is supplied in parts, and takes just a few moments to assemble. To do so,
push the two jacking arms (no. 1) onto the square connecting tube (no. 2) and secure them with the
two grub screws (no. 6) so that they remain in position. Now insert the swing arm supports (no. 3),
with the thread pointing outwards, into the holes at the top of the jacking arms (no. 1) and secure
each support with two washers (no. 5) and a self-locking nut (no. 4). Only tighten the nuts (no. 4)
enough so that the swing arm supports (no. 3) can still be turned in the holes by hand.
14
4
1
6
5
5
3
2