Description Of The Units; Putting Into Operation - Reer Baby Cam Mode D'emploi

Table des Matières

Les langues disponibles

Camera (baby unit/transmitter)

Display (parent unit/receiver)

1. Fully charge the battery before using the parent unit for the first time, until the battery level indicator on the display shows a full charge.

2. Connect the camera using the mains adapter supplied.

3. Place the camera on a stable table or mount it on a wall.

4. Turn the camera on using the On/Off button (2). The power indicator (4) lights up green.

5. Switch on the display by holding the On/Off button (8) for 2 seconds until the status light (13) turns green. If the status light flashes green, it means that the battery

level is low and the parent unit needs to be recharged.

6. he devices are pre-coupled in the factory, enabling you see the camera's picture on the screen and hear the sound picked up by the microphone through its speaker.

If this is not the case, please proceed with the steps described under adding/deleting additional cameras.