Chimney Connection - NECTRE Vermont Bun Baker Manuel D'instructions Et D'installation

Installation
Table 1
Clearances to combustible surfaces
Description
A – Back Wall to Flue Pipe
B – Side Wall to Flue Pipe
C – Wall to Flue Pipe
D – Back Wall to Appliance
E – Side Wall to Appliance
F – Wall to Appliance

Chimney Connection

The chimney connector is a single
walled pipe used to connect the
oven to the chimney. For use
with the N350 Wood-Fired Oven
the chimney connector MUST be
6" (152mm) in diameter, with a
minimum thickness of 24-gauge
black steel or 26-gauge blued
steel. The chimney connector must
be suitable for solid fuel, in good
condition, and kept clean.
Aluminum or galvanized steel pipe
is not acceptable for use with the
N350 Wood-Fired Oven. These
materials cannot withstand the
extreme temperatures of a wood
fire and can give off toxic fumes
when fired.
!
NOTE:
Do not use the
connector pipe as a chimney.
Single Wall Pipe
16.5" (419 mm)
22" (559 mm)
20" (508 mm)
14" (356 mm)
14" (356 mm)
11.5" (292 mm)
Each chimney connector or flue
pipe section must be installed to the
oven flue collar and to each other
with the male (crimped) end toward
the oven, as per Figure 5A. Attach
each of the sections to one another
with three equidistant metal screws,
as per Figure 5B.
Figure 5A
Install crimped
end towards
stove.
Double Wall Pipe
10.5" (267 mm)
18" (457 mm)
15" (381 mm)
8" (203 mm)
10" (254 mm)
6.5" (165 mm)
Chimney connection
Flow Direction
Flue Gases
of
9