Installation; Before Installation - NECTRE Vermont Bun Baker Manuel D'instructions Et D'installation

Installation

Before Installation

After unpacking, check that the
following parts are included inside
the wood-fired oven.
• 2 side baffles
• Handle for air control
• Lifter for cook plates
• Allen key for adjustment
of top air discharge
Assembling your Nectre
Wood-Fired Oven
The Nectre N350 Wood-Fired Oven
comes assembled, however in
transit the side baffle plates may
have shifted. Make sure they are in
place on each side of the firebox.
The baffle plates have tags that
hang over the firebox wall. The
firebricks may also shift in transit,
make sure these are in position
before lighting.
Installing the by-pass
Damper
1. Before installing the flue, the
by-pass damper handle must
be fitted. The handle is supplied
inside the firebox. Insert the
threaded end of the handle into
the 10mm (0.40") hole on left
side of the oven. Looking down
through the flue spigot locate the
threaded end of the handle with
the extended nut attached to
the by-pass damper. Screw the
handle all the way into the nut
until tight.
6
D
Wood-Fired Oven
E
Hearth
2. The position of the handle should
be at approximately 11 o'clock
when the damper is open, and
1 o'clock when the damper
is closed.
!
NOTE:
adjustment range to increase firing
for any reason.
Installing Fire Bricks
The oven comes with 4 fire bricks
9" x 4½" x 1½" (230 mm x 115 mm
x 38 mm). Refer to Figure 1.
Place the four fire bricks upright, up
against the rear wall of the firebox.
Place the U-shaped brick retainer
over the top of the bricks such that
the bricks fit inside the U-section.
This will hold them in place. Place
the triangular firebricks at the front
of the firebox beneath the door
opening.
!
NOTE:
already be in place upon arrival of
your wood-fired oven.
Figure 1
C
Firebox side
shield
A
B
F
A = 8" (203mm)
Do not alter the damper
The firebricks may
Flue By-pass
www.nectre.com/usa-nectre
Canada
Damper
Rear
Firebricks