Dismantling / Disposal - Ecolab DG 1-II Notice D'utilisation

10

Dismantling / Disposal

Dismantling
The DG1-II may only be dismantled by specialist personnel. Before commencing
dismantling, ensure that the
The device must be flushed through with care in order to get rid of any residual chemicals.
417101158_DG1.docx
DG1-II
Disposal
The DG1-II is predominantly made of steel (and also of aluminium to a
certain extent) (apart from the electrical equipment) and is to be disposed of
in accordance with the local environmental regulations prevailing at that
time.
Depending on the condition, existing regulations and with due regard for
current requirements, dispose of it, for example, as
electrical waste (printed circuit boards), plastics (housing), metal plates,
steel, copper, aluminium (separate after sorting). Prior to disposal, all parts
which are in contact with media must be decontaminated.
Oils, solvents, detergents and contaminated cleaning tools (brushes, cloths,
etc.) must be disposed of in compliance with local requirements, in
accordance with the prevailing waste code and with due attention to the
notes contained in the manufacturers' safety data sheets.
has been fully isolated from the power supply.
48 Rev. 07-01.16