Shifting Suction Pipe And Mains Cable To Left-Hand Side Of Housing - Ecolab DG 1-II Notice D'utilisation

5.4

Shifting Suction Pipe and Mains Cable to Left-Hand Side of Housing

To shift suction pipe and mains cable to the left-hand side of the housing, proceed
as follows:
 Remove the cover (Fig. 3.1, pos. 1).
For this purpose, unscrew the two cover screws (Fig. 3.1, pos. 8).
Lift the cover to remove it.
 Detach the hose clamp, unscrew the coupling nut (Fig. 3.2, pos. 10) from the suction
pipe, and pull the suction pipe, along with the suction line and the connecting cable, out
of the housing.
 Pull the mains cable bushing out of its holder and retract it into the housing, together
with the mains cable.
 Remove the cover plate at the left-hand side of the housing.
 Use the cover plate to close the cable opening at the right-hand side of the housing.
 Pull the mains cable through the left-hand opening of the housing and attach the cable
bushing. Make sure that the cable is not damaged and cannot get in touch with any
sharp-edged parts (leave the internal mains cable attachments in place).
 Fit the suction pipe to the left-hand side of the housing
417101158_DG1.docx 37 Rev. 07-01.16