Installation Modes; Coaxial Pipe; Single Wall Pipe And Free Air Intake; Single Wall Pipe And Outside Air Connection - CASATELLI TOMMASO G Manuel D'installation Et D'entretien

6 INSTALLATION MODES

You can install the stove in different ways:

6.1 COAXIAL PIPE

It is possible to use a coaxial pipe for smoke outlet
and air intake.
To do this, simply connect a coaxial pipe, because
the stove is already configured for this type of
installation (6.1).
The technician is responsible for chimney
dimensioning according to the situation of
the installation and the product used. It is
recommended not to exceed 7 meters equivalent
with a coaxial tube of 13/8 cm.
6.2 SINGLE WALL PIPE AND FREE AIR
INTAKE
In this case the combustion air will be taken from
the room.
Disassemble the back of the stove (a) and
disconnect the combustion air hose (b); connect
the flue pipe (e) after mounting the aesthetic ring
holder (c) and the ring (d) as shown in figure (6.2).
Replace the back
Make sure you have made an adequate air intake in
the room, as specified in the previous paragraphs.
6.3 SINGLE WALL PIPE AND OUTSIDE
AIR CONNECTION
In this case the combustion air will be taken directly
from outside by the rear of the stove.
Disassemble the back of the stove (a) and
disconnect the combustion air hose only in the
upper side (b); connect the flue pipe (e) after
mounting the aesthetic ring holder (c) and the
ring (d) as shown in figure (6.3); Remove the
pretrimmed on the back (f), and pass through hose
to connect it to an external air intake. Replace the
back panel.
26
panel.
00 477 5831 - 04/04/2019 - PN - Italy
INSTALLATION
E
: enlever la piece - : monter la piece
E
: enlever la piece - : monter la piece
D
C
B
A
D
C
F
B
A
fig. 6.1
fig. 6.2
fig. 6.3