Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Operating Instructions
Troubleshooting Chart
Symptom
Right or
left heavy
spray pat-
tern
Top or
bottom
heavy
spray pat-
tern
Split spray
pattern
Center
heavy
spray pat-
tern
Sputtering
spray
Fluid leaking from pack-
ing nut
Air leaking from air cap
without pulling trigger
Fluid leaking from fluid
tip of pressure feed
spray gun
Excessive overspray
Possible Cause(s)
1.
Holes in left or right side of the
air cap are plugged
2.
Dirt on left or right side of fluid
tip
1.
Dried material at top or bottom
of fluid tip
2.
Loose air cap or dirty seat
3.
Air cap plugged
1.
Fan pattern open too far
2.
Fluid turned in too far
3.
Atomization air too high
4.
Fluid pressure too low (pressure
feed only)
1.
Fan adjustment partially closed
2.
Material too thick
3.
Atomization pressure too low
4.
Fluid pressure too high (pressure
feed)
1.
Material level too low
2.
Container tipped too far
3.
Loose fluid inlet connection
4.
Loose or damaged fluid tip/seat
5.
Dry or loose fluid needle packing
nut
6.
Air vent clogged (siphon only)
1.
Packing nut loose
2.
Packing worn or dry
1.
Sticking air valve stem
2.
Contaminate on air valve or seat
3.
Worn or damaged air valve or
seat
4.
Broken air valve spring
5.
Bent valve stem
1.
Packing nut too tight
2.
Fluid tip worn or damaged
3.
Foreign matter on tip
4.
Fluid needle spring broken
1.
Too high atomization pressure
2.
Too far from work surface
3.
Improper stroking (arcing, gun
motion too fast.)
Corrective Action
1.
Clean. Use only non-metallic paint
2.
Clean
1.
Clean
2.
Clean and tighten
3.
Clean. Use only non-metallic paint
1.
Partially close the pattern adjustment
2.
Increase fluid
3.
Reduce atomization air pressure
4.
Increase fluid pressure
1.
Open fan pattern adjustment
2.
Thin to proper viscosity
3.
Increase atomization pressure
4.
Reduce fluid pressure or turn in fluid control knob
1.
Refill
2.
Hold more upright
3.
Tighten
4.
Adjust or replace
5.
Lubricate and or tighten
6.
Clear vent hole
1.
Tighten, but do not restrict needle
2.
Replace or lubricate (non-silicone oil)
1.
Lubricate
2.
Clean
3.
Replace
4.
Replace
5.
Replace
1.
Adjust
2.
Replace tip and/or needle
3.
Clean
4.
Replace
1.
Reduce pressure
2.
Adjust to proper distance
3.
Move at moderate pace, parallel to surface
6
HDS Model Series
Publicité
Table des Matières
Dépannage
