Data Copying - Alcad 912-US Serie Manuel D'installation Et Programmation

28 - ENG
The
permits selecting standard channels, while the
shift between standard or S band channels.
The message
frequency to be selected in 0.25 MHz jumps.
We recommend indicating the output channel or output frequency
programmed in the box planned for it in the receiver.
5.4 Automatic tuning of satellite channels
Press the t and u keys to enable tuning towards lower frequencies
T to initiate the tuning of the next channel. The AFT OK led will blink
during tuning. Press the T key again until finding the desired channel.
The automatic tuning system is controlled by a microprocessor that permits
the exact tuning of satellite channels.
5.5 Remaining functions
Select the desired value as shown in section 4 DESCRIPTION OF THE
PROGRAMMER: SERIES 912 - US.
6.

DATA COPYING

To avoid transmitting one by one all the data in module US in installations
where the only difference between one module and the other is the output
frequency, mode TV, and of course, the output channel or output
frequency, the COPY function can be used.
Make sure that the values of every function, except the previously
indicated ones, correspond to the values sought for your installation.
Aiming at the receiver, press the F and COPY keys. The PS programmer
must be kept aimed at the receiver until the
deleted from the screen.
transmitting.
Next, select the input frequency, the output channel or frequency, and the
TV or Radio mode for each module separately, as per section 5.2 DATA
TRANSMISSION.
This function can act upon every receiver in a framework, at the same
time, by placing the PS programmer at the right distance and turning ON
the programming switch of the corresponding receivers.
Installation and programming manual
permits selecting S band channels. Press the C/S key to
or towards higher frequencies
displayed on the screen allows the output
the programming led will blink while
indication on the screen
. Then press
message is